-
1 Attachment(s)
IB-5 Wiring
I started wiring my IB-5 that I started a couple of years ago. The instructions talk about the hot wire as being white, however the pups in the kit have the white twinned with a red wire, which I assume is for coil splitting.
So, am I right in assuming that the black in this case is the hot wire and the green with the bare shield is the earth? (See attached photo)
-
Yep, the factory has changed from 2-wire (hot and bare) pickups to 4-wire (plus bare shield) versions.
Black = hot (connect to volume)
Red & White = series link between coils (leave joined and just insulate the tip so it can’t short if you’re not doing coil splits)
Green & Bare = ground and shield (connect them to your ground point, back of pot etc)
-
So is black North start and red North finish?
Sent from my ONEPLUS A3000 using Tapatalk
-
Black = north start (hot)
White = north finish
+
Red = south finish
Green = south start (ground)
-
There were only two choices. I knew I'd get it wrong. Murphy's law ;-)