Finished in Amaranthine. Mother of pearl inlay.
http://pitbullguitars.com/wp-content...o306-image.jpg
http://pitbullguitars.com/wp-content...uhv3-image.jpg
http://pitbullguitars.com/wp-content...a85y-image.jpg
Printable View
Finished in Amaranthine. Mother of pearl inlay.
http://pitbullguitars.com/wp-content...o306-image.jpg
http://pitbullguitars.com/wp-content...uhv3-image.jpg
http://pitbullguitars.com/wp-content...a85y-image.jpg
Young recipient used his bass for a school recording project!
http://instagram.com/p/dbjx2coBUn/
EX-1 finally done.
Been a long time getting this one finished and below I have listed all the mods and upgrades:
5 Coats Dingo Tone Coolangatta Gold Base Stain
5 Coast Dingo Tone Coolangatta Intensifier Coat
20 + (maybe even more) coats of Tru Oil
Dingobass Bone Nut and Neck Setup - best investment anyone can make. Awesome job and many thanks DB.
2 x Bourns 500k Audio Taper Push Pull Pots - one used to split neck PUP to slugs and the other to split bridge PUP to screws
Set of Tonerider Alnico IV Classic Vintage Voiced Humbuckers
1 x Sprague 0.022 Orange Drop Tone Capacitor
1 x Fidelity resistor & capacitor volume control upgrade
1 x Gotoh 3 position switch
1 set of Grover Locking Tuners
1 x Rosewood Truss Rod Cover
Dingo Tone Wax used on Rosewood Fret Board & Truss Rod Cover
Cat music Conductive Shielding Paint
Epiphone genuine Explorer Hard Case
Only standard parts used were the Bridge, Tail Stop, Strap Buttons & end jack plate and 1/4" socket as too hard finding a black retaining nut for a switchcraft one as threads differ.
Attachment 10869Attachment 10870Attachment 10871Attachment 10872Attachment 10873
http://www.buildyourownguitar.com.au...ead.php?t=4551
Not your average EX-1, but not too far removed either.
Attachment 16717Attachment 16718Attachment 16719Attachment 16720
Body painted with Maston black acryl spray and lacquered with Maston acryl lacquer spray. Finished with Sonax car wax.
Humbuckers 12-13 kOhm from Ibanez.Attachment 17544Attachment 17545