Cut and polish on Dingotone

Alright I am coming into the home stretch of the staining finishing process, looking to do a final cut and polish on the Dingotone final coat. I have seen lots of builds using the Meguiar's car polish and micro mesh sanding pads on Tru oil finishes, does this same method hold true for Dingotone? I am not trying to get a glass like finish, just a nice even semi-gloss that shows off the grain. I have done 4 top coats with very light wet and dry sand at 1200 then 1500 between every second coat to get some of the dust particles and stray fibres off and to key it up for the subsequent coat, is this sounding about right?

I've always used DB's trusty photocopier paper method, but I've never been too fussed with high gloss finishes. I'm not sure if you will be able to get the same high gloss finish as you can get with Tru-Oil (just trying to manage your expectations). DB always called it a semi-gloss finish. Others will pitch in with their experiences.

Hi Fretworn, I am not chasing a high gloss finish on this one, just want the grain to come through. What is the 'photocopier paper method'? Haven't come across a reference to that one yet. BTW for those that use Meguirars, what exact type are you using?

DB's photo copy paper trick.

Quote:

---

Originally Posted by WeirdBits

DB's photo copy paper trick.

---

Cheers Weirdbits

To answer your Maguiers question: ultimate compound for the main cut and scratch x for the final polish

Be careful as DT takes a very, very long time to cure and harden up. Tend to think if the copy paper developed an edge it may introduce rather blunt scratches in the surface.

I have never made it past Intensifier coats but from I have seen and read if I was to use the stuff again it would seem that the clear neck finish may work best as the final top coat all over as it is supposed to be a harder finish and therefore not so prone to scratches and minor dents.

Thanks for the replies on the Maguires and the timely reminder to be patient at this stage Waz, I think I will do at least one coat of neck finish on the body. I am still not 100% happy with the neck colour matching the body, still looks to yellow compared to the body, but I'll give it one more intensifying coat then move on or this guitar will never be completed. I can see why you use tru oil :)

DT = lots of patience required

Sent from my SM-A520F using Tapatalk

Quote:

---

Originally Posted by wazkelly

DT = lots of patience required

Sent from my SM-A520F using Tapatalk

---

Hence my use of a 2 part epoxy on the next build 😄

That's going from one extreme to another as epoxy can prove tricky to finish off too.

Sent from my SM-A520F using Tapatalk