PRS-1Q by AxeMurderer

Looking great Axe. What grade paper did you use to sand back the base?

Amazing burst

Quote:

---

Originally Posted by ILRGuitars

Looking great Axe. What grade paper did you use to sand back the base?

---

Thanks ILR. I originally went to 400 prior to dying then used both 240 and 320 to take the dye coat off. I think I had it too smooth to start with. Doing it again I'd stop at 320.

Great looking burst Axe!!

That's a great burst. It gives me hope that I may yet salvage some pride with my first PRS build. (Now where did I put that pile of sandpaper?)

Quote:

---

Originally Posted by Muzza

That's a great burst. It gives me hope that I may yet salvage some pride with my first PRS build. (Now where did I put that pile of sandpaper?)

---

Its always in the place you least expect it. Try the freezer.

I was hoping the sanding part was over...

Oh Muzza....the sanding is never over.

A couple of coats of shellac sprayed on as a base for the oil finish.

http://uploads.tapatalk-cdn.com/2016...8925958ec8.jpg

http://uploads.tapatalk-cdn.com/2016...e9492ed134.jpg

Tonight we sand.


Sent from my iPhone using Tapatalk

Meanwhile, veneering and shaping the headstock.

http://uploads.tapatalk-cdn.com/2016...1565c426f2.jpg

http://uploads.tapatalk-cdn.com/2016...22f98460d6.jpg