AHHHHHHHH!!!! ok then, so im guessing the power switch isn't in the diagram yet?
Printable View
AHHHHHHHH!!!! ok then, so im guessing the power switch isn't in the diagram yet?
You'd be guessing wrong! ;)
The reverse switch is in the original schematics....
I just reproduced the wiring diag for you. I wanted effectively a kill switch which is what the front switch does.
I didn't need to install it. Also, the Red 'reset' switch was unnecessary as the counter had its own built in reset switch.
ok, so can you please post the diagram for the on/off switch???
It's not needed and will possibly confuse folks. Plus if you really want a picture of an on off switch it can always be googled!Quote:
/<\\/p>[/<\\/p>[]<\\/p>/]<\\/p>/Quote from keloooe on June 18, 2013, 13:36
ok, so can you please post the diagram for the on/off switch???
is it similar to kill switch from a guitar???
Here is a typical on/off switch.
http://pitbullguitars.com/wp-content...y3cr-image.jpg
my winder is basically finished now, only need to make/ get some guides for the shaft that I made up from a 6.5 mm steel rod. made short movie of it, but am having difficulty in uploading it from the phone now.. bugga!
oh, that reminds me, where;s a good link to the hardware for the shaft that holds the bobbin holder, and also links to hardware for the traverse limiter???
https://dl.dropboxusercontent.com/u/.../VIDEO0015.mp4 bit rough, but show it running .
Nicely done AJ - like it! What'd it end up setting you back?