Les paul mahogany kit build.

Looks great and sounds great. I hope can get the action a bit lower. Hopefully lowering the nut action will fix these issues.

Quote:

---

Originally Posted by Simon Barden

Yes, it’s standard practice to spray clear over the binding. You don’t have to, and I know a few people on the forum kept the bindings taped up. If you don’t spray over the binding you’ll probably get a step round the edge of the binding. The clear coat is a very good way to remove any height difference between the binding and the body.

With a bound neck, the common practice is to spray clear over the binding on the sides of the neck, but to keep the top of the fretboard fully masked and to scrape off any clear that creeps under the edges, so the upper binding surface sits flush with the fretboard. Spraying over the binding on the side is another way of ensuring a smooth transition between neck and binding. Any ridge here can feel awkward under your fretting hand.

---

I'm about to start applying poly on a guitar with binding on the body and neck and was wondering how to go about the neck. I used the search bar to find this topic and deep down I knew that you would have helped someone else with the same question. Thank you, Simon!

Quote:

---

Originally Posted by Juanito

I'm about to start applying poly on a guitar with binding on the body and neck and was wondering how to go about the neck. I used the search bar to find this topic and deep down I knew that you would have helped someone else with the same question. Thank you, Simon!

---

Hi Juanito,
Simon has not been around the forum lately!:(
On my DSCM-1 kit I sprayed clear on the sides of the neck binding, but not the top of the binding. I scraped any that did end up on the top of the binding. Yes - like mentioned on SB's second paragraph. Then oiled the fretboard.