Crane fabric top TL-1

Quote:

---

Originally Posted by McCreed

Very nice.
How are you going to finish the edge where the fabric rolls over? Some kind of piping or something?

Also to backtrack a little, I'll third the flap disc on an angle grinder as well. Just need to go slow as it will remove material very quickly.

Keep the pics coming too!

---

There is how the edge looks like at the moment, there is a 1-2 mm indentation. I was hopping to build up enough clear resin that I can do a flush trim at the end.

https://lh3.googleusercontent.com/F_...=w1250-h937-no

That’s a real cool look, I have couple of friends that have done cloth tops with great results.
Wayne.

Done the flood coat of clear resin tonight. Looks promising so far.

https://lh3.googleusercontent.com/i0...=w1000-h750-no

https://lh3.googleusercontent.com/hZ...Q=w703-h937-no

Looks good, can’t wait to see the final piece.


Sent from my iPhone using Tapatalk

Man that is special...absolutely stunning work. Well done!

Looks very nice, i vove the matial and placement. Is the edge channel deep enough to put binding on? That might be a nice way to hide the material edge.

Quote:

---

Originally Posted by infxualbydesign

Looks very nice, i vove the matial and placement. Is the edge channel deep enough to put binding on? That might be a nice way to hide the material edge.

---

No is not deep enough, I wish I had the router bit for binding that I could do this better, will be so much easier to hide the edge with the binding. Spend last few days redoing the edge, but not a lot of luck so far. I am on the edge of giving up and leave it as it is.

Finally I have finish the headstock.

https://lh3.googleusercontent.com/i_...Q=w820-h616-no


https://lh3.googleusercontent.com/du...jyHXLQ=s937-no

Quote:

---

Originally Posted by Kac

No is not deep enough, I wish I had the router bit for binding that I could do this better, will be so much easier to hide the edge with the binding. Spend last few days redoing the edge, but not a lot of luck so far. I am on the edge of giving up and leave it as it is.

---

KAc

I see you are in Perth...

If you send me a PM with your contact number I'll help you with the routing channel for the binding...

Quote:

---

Originally Posted by Gavin1393

KAc

I see you are in Perth...

If you send me a PM with your contact number I'll help you with the routing channel for the binding...

---

Thanks for the offer, but I have no plans to do the binding for this guitar atm. Maybe in the future project.