Looks good, Waz! Through in some red highlights and it can be a Four-Ex-1
Printable View
Looks good, Waz! Through in some red highlights and it can be a Four-Ex-1
Looking good, Wazza.
However, you are sentenced to six month in the NW to undergo beer re education....
Honestly, XXXX and Corona???
Bwaha see you in the naughty warehouse Waz.
I'll serve you some quality craft beers. We will re educate you mate
Colour is looking good Waz
Hold that thought Swanny as you have just given me some inspiration for the headstock. This guitar will now be known as the XXXXplorer. Rough mock-up below and as I have mainly been drinking cans lately didn't have any labels and had to cut out part of the carton instead.Attachment 7386
You lot should come for a visit.....Beer City, U.S.A. is ready to tempt your palates.
Hey Waz,
I've just started on the EXA-1 kit, though I am trying to rework the neck heel to create a smooth transition between neck and body. Nothing spectacular with the electrics, just a standard EMG ZW set, on a 3 position toggle.
If I may ask, what bridge and tailpieces are you using? I ran with a standard Gotoh set (Black) and I've found that they are not quite a neat fit to the drilled holes. Did you have a similar experience?
Cheers,
Hi Franken, just running with the standard black bridge & tail piece that came with the kit and from mock build stage it all seemed to fit OK. Only other stock hardware I am using are the knurled control knobs, output socket plate and rear control cavity cover.
My first attempt at a set neck and can see why you want a smooth transition from heel to body however as it is on the back it will not be seen and probably way too hard to make it look good unless you run with a painted solid colour finish. For PUP's I chose Tonerider Alnico IV with 4 wire as I plan to wire split coil and series/parallel to see what sounds can be created.
Have read on some other forum threads where guys have had to fill and re-drill holes for bridges and was a bit worried at first and hope for your sake that is not required. Did you keep the stock parts as if they fit maybe it would be better to run with that instead?