Printable View
It's all good I just scored some SM glue (well the missus did anyway):-)
Proud on the edge or the top? And you're saying you can actually rout the binding flush?
Next time you do a binding job you should make a video, it's so much easier to learn when you're actually watching someone do it.
Cheers for the info though DB!
Proud of the side edge. You should have a flush cut bearing in your kit :)
It is also good to have it sitting proud of the top as well.
You can scrape this flush later.
I didn't buy the whole kit DB, it was just too much to fork out in one hit, I only got the rabbeting bit and the one bearing I needed for this specific job (1.5 mm rebate) I'll look into adding to the collection further down the track as I need them.
No problem, you can scrape the bindings by hand.
Yeah roger that, improvisation's my middle name:-)