Nice work PeMe, what thickness was the steel you used for your forming die?
Printable View
Nice work PeMe, what thickness was the steel you used for your forming die?
Have just painted my headstock where I plugged the holes. Give the primer time to shrink back before committing to your top coat and gloss. Even after doing all that I could still see the old tuner holes. Just saying. I used Nitro tho.
+1 to this. I had similar experience with plugging tailstop anchor holes in my LP build. At least 48-72 hours cure time per coat (Rustoleum 2x flat grey primer), plus a light wetsand (P1000) between each second coat to finally get a smooth finish across the plugs. I think i ended up with 6 coats on it prior to going back to colour.Quote:
Originally Posted by JB RETRO
Hope you have checked spacing between each tuner from the rear as from the front it didn't look too far off from being right?
The steel is 1,5mm thick. I didnt sand or smoothen the whole out so the sharpness of the whole could do its work.Quote:
Originally Posted by FrankenWashie
There was nothing wrong with the spacing of the wholes, but i will reshape the whole headstock so the wholes needs to me redrilled.Quote:
Originally Posted by wazkelly
OK, fair enough and understand that 12 tuners take up a lot of real estate.
Been down at my workshop for a couple of hours and getting closer for some paint on the body
Attachment 20719
Ive also started to work a bit on the headstocks
Attachment 20720Attachment 20721
Oooh, that headstock work looks nice!
I had some issues with the primer vs paint and needed to sand it all down to bare wood and apply another primer that was compatible with my main paint.
so after a few days of frustration im now at where i was a few days ago, but this time the paint wont crack when i start to paint the guitar and necks.
Ive learned the hard way that you need to know BEFORE you start to put on the primer if it is compatible with the 2 componet paint and if you aren't shure, test it on some scrap wood you have lying around so you dont need to put loads and loads of work into sanding down to bare wood.
Here are some pics of where im currently at in the progress.
Body and necks
Attachment 20929
Headstocks
Still love the grain on the 6-string neck
Attachment 20930
The body, ive reposition the controlls bit as i felt that the bridge would be in the way.
I've also moves the jack to the front just because i can :p
Attachment 20931