I'd glue the two shims together first, then glue the shim into the pocket, and then glue the neck on.
I wrap cling-film over the wooden blocks I use when clamping, if there's a chance of glue oozing out and sticking the block to the clamped item.
Printable View
I'd glue the two shims together first, then glue the shim into the pocket, and then glue the neck on.
I wrap cling-film over the wooden blocks I use when clamping, if there's a chance of glue oozing out and sticking the block to the clamped item.
Hi Simon, Thanks for the great tip, will do just that!Quote:
Originally Posted by Simon Barden
Hi Guys
After a break, have gotten back into it. I’ve glued the two shims together and have clamped them down.
Also started the process of installing the bone nut. I’ve also removed the nut and it popped out without too much damage
https://uploads.tapatalk-cdn.com/202...a044655d3d.jpg
There is still some dried up glue residue on the base, I’ll try to sand it or file it off. Any tips on installing the nut? Just been following some YouTube videos
Also looking at some advice, at the base of my neck pocket with the shim
In place, there is a bit of a gap. One I’ve glued in the neck with the shim, was thinking of making a mixture of sawdust and the shellac I’ve been using, to use as a wood filler to fill in the gap and then sand to smoothen. Any advice if that’s ok ?
https://uploads.tapatalk-cdn.com/202...e44c2388af.jpg
I'd consider staining the shims the same as the back and neck, then drop filling with CA, then continue with more coats of your clear.
Looking good Vivek.
Sent from my iPhone using Tapatalk
thanks Mcreed, I’ve put in an order for some CA glue,Quote:
Originally Posted by McCreed
Still a long way to go! [emoji38]Quote:
Originally Posted by mrpearson
Ah, rookie mistake. I glued the two shims on the wrong side. I’ve had to
Flip it to fit, now the 1mm shim
Is on the bottom. However the angle of the neck is still relatively the same, so I think I might just use this, rather than make a new shim. There is a bit more of a gap in the between the neck joint and the shims.
But I’ve to check, but I think my pickups might not fit as the neck heel is higher. Have to test mount them.
https://uploads.tapatalk-cdn.com/202...ee8261536c.jpg
https://uploads.tapatalk-cdn.com/202...280a9a558f.jpg
Also dry fitted the new nut, it’s shallower than the original
https://uploads.tapatalk-cdn.com/202...f9c049b33b.jpg
https://uploads.tapatalk-cdn.com/202...da6c12d366.jpg
Decided to flip the shim as it was, and sand It down on the side to conform to the pocket. It fits better..
https://uploads.tapatalk-cdn.com/202...2895b62a3b.jpg
Sent from my iPhone using Tapatalk
Back again with another update, still very slow…have just glued the shim to the body. Once it’s set, will fit the neck again, sting it up for a check and then glue in the bone nut. Going very slow but it’s ok.[emoji3]. One things I’ve learnt from this build is how to make shims, have now made some diy shims for my telecaster build and a cheap strat, world of difference in terms of playability!
https://uploads.tapatalk-cdn.com/202...3b400d9243.jpg