Brass Nut on ES-1G

hi,

anyone installed a brass nut on the es-1g?? If so any particular brand that fits without too much grief...
also don't suppose anyone has dimensions for the es-1g specifically from the centre of the tail peice to the rear strap pin hole.

Cheers

Realtone supply the brass nuts.

www.realparts.com.au

Thanks man appreciate it!

Hey I noticed 4 types of brass nuts on realparts, did you go for the Gibson one?

Quote:

---

Quote from sam.grossmann on October 11, 2014, 23:56
...dimensions for the es-1g specifically from the centre of the tail peice to the rear strap pin hole.

---

Approx 205mm.
http://www.pitbullguitars.com/wp-con...piece2butt.jpg

Quote:

---

Quote from sam.grossmann on October 12, 2014, 09:01
Hey I noticed 4 types of brass nuts on realparts, did you go for the Gibson one?

---

The Gibson would be the closest match (but may not be perfect, and is perhaps .8mm too long), the other three are Fender style. Shame they don't stock G-style blanks too.

Quote:

---

/<\\/p>[]<\\/p>/Quote from sam.grossmann on October 12, 2014, 09:01
Hey I noticed 4 types of brass nuts on realparts, did you go for the Gibson one?

---

Yeah, the Gibson one is near perfect...just may need to take it down a bit, but sandpaper works well with the brass.

Thanks again!

Hope you don't mind but I may have a few other questions down the line... I'm only comfortable with electronics, but everything else in the build is new to me.
You seem very experienced and I wouldn't mind picking ya brain on a few things.

Thanks again mate.

Nice one scott thanks man.