Printable View
Hey Guys!
I have 2 things..I was wondering if anyone had any ideas on before I start re-wiring things.
My LP is humming when I plug it in, it stops when I touch a pick up or the 3way or the input jack. Its more defined on the bridge pickup. Is that a problem with the grounding?? I am not sure I want to plug it in again until I have fixed it
Also on the bridge pickup only between about 80-90% volume it cuts out, when i go past there and before there its fine.
Other then that I love it :)
Check your output jack and make sure the wires haven't been reversed.....Been there myself and done that...
When wiring your guitar you create a circuit. The humming sounds you expect to filter out of the guitar via the earth/ground wires...
When your guitar is silent until you touch the strings (which are in contact with the bridge, which in turn is [supposedly] in contact with the earth wire) what is happening is that your body is becoming the earth wire. This suggests that your bridge isn't running through to ground until you touch the strings and hence are completing the circuit to ground.
Switch the output Jack wires around and see if that makes any difference. If not check all your ground joints especially at the solder points. You may have a dud joint.
This may solve the Pot issue, but if it doesn't, change the pot...the pot may either be faulty or dirty.
Yerp, I am with Gav.... been there, done that!
I guess as long as its humming the same tune that you're playing it could be bonus ... saves to having to pay for a back-up singer! :D
... sorry 'bout that, I'll go now ...
I also experience the same problem but the hum goes away when I play outside in the living room with the same amp. I shielded the guitar too, but I suspect it's caused by EMI. That's annoying!
Another possible cause of a hum is a mobile phone. Make sure there is no mobile phone near the guitar or amp.
Another thing worth looking for is dry joints. Check that all soldering is nice and silvery, not frosty. Also check that there is good jointing between the wires and tabs or pot housings. If in doubt, resolder the joints and get a good flow with good heat. Don't overheat the joint but make sure that the heat is there long enough for the solder to run properly.
I also noticed certain kinds of lighting and also computer monitors have made it worse.
Sounds very much like a shielding/grounding issue to me. I'd be checking those first.
Did you shield the cavities? If so, did you connect/solder the shielding to the ground of the rest of the electronics?
I have the exact same problem with the LP that I have recently wired up. I have triple checked my wiring and solder joints and they all look good.
I haven't shielded the cavity's, I am going to shield them today and see if that helps.
I am thinking the three way switch may be the cause. I just don't like the look of it, and I suspect it may have grounding issues. I will also try replacing the tree way switch.
I also question if the ground wire has a good purchase on the bridge post. I'm 99% sure it's fine, but you never know
The hum is not too bad at home with few interference's, but in my mate's music room that's full of electronic's the hum was unbearable. The most hum I've ever heard from a guitar.