4 Attachment(s)
Next 3 coat spray after 1200grit wet sand.
After a couple of coats of Tru-Oil and I did not like the stain....sanded back to bare wood and started again. Now we have gone back through the grits, ebony Timbermate and poly coats to......here.....
The body and the neck on this one have now been wet sanded through to 1200 grit. Just sprayed with the third coat, 10 mins apart, of Poly....and here she is.
4 Attachment(s)
Body poly polished and waxed.
The body and neck are done as far as poly etc goes. Taped up the neck...got it flat....then levelled the frets...crowned them...rounded the ends over then smoothed with 400 grit 600 800 steel wool and autosol. Super smooth, round ends and polished and shiny.
This kit has not neck mounting screw holes and no under bridge ground wire hole. So did the neck first...went well. Then the body ground wire hole.
I have been thinking for some time that my long drill bit....is still a little short. But you persevere....just as the tip poked out in the control cavity it broke at the chuck. Bugger. Now how the hang do I get that 6 inch drill bit out of the body?????