Kick
28-03-2017, 06:46 PM
Perhaps a stupid question but I ordered black hardware with my LP-1MQ kit. The PU's do not have the screws in the polepieces as you would see in the chrome or gold version.
Looking at the PU's already installed in the PU rings, I assume that when I put the rings (with PU's) in their cavity as they should be (looking at the angle of the PU rings and the lenght of the wires) that the polepieces underneath the black plate are pointing in the correct way. That is: polepieces towards the bridge for the bridge PU and polepieces towards the neck for the neck PU.
But... Assumption is the mother of all f*ckups so is there a way I can check if the PU are correctly pre-installed in the PU rings?
Looking at the PU's already installed in the PU rings, I assume that when I put the rings (with PU's) in their cavity as they should be (looking at the angle of the PU rings and the lenght of the wires) that the polepieces underneath the black plate are pointing in the correct way. That is: polepieces towards the bridge for the bridge PU and polepieces towards the neck for the neck PU.
But... Assumption is the mother of all f*ckups so is there a way I can check if the PU are correctly pre-installed in the PU rings?