P90 and humbucker wiring diagram

[neverwas]

For my next build, considering using a P90 in neck position and a humbucker at bridge.
Thinking of Kent Armstrong noiseless P90 (4 wire) and maybe Tonerider AC2, also 4 wire, one vol, one tone, 3 way switch, with a push-pull to split humbucker to slug coil.
Haven't found a wiring diagram for that combo, so have edited a 2 HB diagram to suit, I think.
Will this layout work, or is there a better way?
Any advice greatly appreciated.

Grant

[wokkaboy]

Hey Grant, I think that diagram should work with no split coil on the P90. What kit is it going in ?
Better wait for wiring guru Weirdy to chime in sure he can show other ways to achieve the same specs. Been a while since I looked at split coil diagrams so I am only guessing.

[neverwas]

Wokks, custom ordered a JR-1 kit as a sort of semi-scratch build, thats what this is for. No firm build plan yet, will start a diary for it soonish.

[wokkaboy]

sounds good Grant, so presume you have to route pup cavities maybe ?

[neverwas]

Yeah Wokks, only the neck pocket routed, need to do pup routs and bridge posts. I wanted to do my own control cavity but the factory had other ideas, now need to work with/around theirs. Will all be good in the end I hope.

[wokkaboy]

no worries Grant, think the JR-1 control cavity is just a long skinny cavity similar to a tele so you can always enlarge it, can't shrink it without glueing pieces of timber in !

[WeirdBits]

Grant, that layout will short the bridge hot (north start) to ground when the push/pull is up, not what you want. Instead of the red link wire to the middle lug on the push/pull it should be the north finish/south finish series link, then with the push/pull up it will connect the link to ground giving you the slug coil. Diagram 3 on the Tonerider humbucker diagram (http://www.tonerider.com/files/humbucker-wiring-2014.pdf) should be the setup you want for the split to slug coil.

[wokkaboy]

good one Weirdy to the rescue. I've used diagram 3 on Tonerider pups in bridge position

[neverwas]

Thanks Weirdy, have re-edited drawing to suit
12648

Cheers

Grant

[WeirdBits]

Yep, that should do it. Just remember to check for any phase issues when you're mixing different brands of pups, you will sometimes need to reverse one of them.

[neverwas]

Will make a note of that. Thanks again.