PDA

View Full Version : Dyeing your guitar top



kimball492
06-07-2016, 02:57 PM
https://youtu.be/B0FStByxOGE

Zandit75
06-07-2016, 04:58 PM
Good video, however the heavy sanding he does to this top is not going to work on the thin veneers we see on the PitBull kits.
The guitar he is staining has a thick veneer on it that you can see on the close ups. It looks to be about 8-10mm thick.
Compare that to the approx 0.6mm veneers on the Pitbull guitars, and you can seriously damage the top with 150grit paper.

kimball492
06-07-2016, 05:52 PM
That's not a veneer as much at its a solid cap Zandit. Solid caps are much thicker. And normal practice on Les Pauls, Prs Guitars etc. But good point about not sanding thin veneer tops heavily.

wazkelly
06-07-2016, 07:24 PM
Easiest way to solve that is using a wet rag 12-24 hours later to take off some of the dye colour finish if it has come out too strong or dark and thus overpowering the quilt that was meant to be accentuated. Saves risking sanding through the preciously thin veneer cap.

FrankenWashie
06-07-2016, 08:02 PM
Easiest way to solve that is using a wet rag 12-24 hours later to take off some of the dye colour finish if it has come out too strong or dark and thus overpowering the quilt that was meant to be accentuated. Saves risking sanding through the preciously thin veneer cap.

Good to know, I assume we are talking damp to touch not wringing wet?

wazkelly
06-07-2016, 08:12 PM
Yep, just damp and rinse it out in water after each wipe a few times until not much more colour comes out after each rinse as that indicates you have reached point of maximum absorption back into the rag or cloth.