So I was digging through one of my many boxes of cables and gear recently and came across this old wah pedal I'd completely forgotten about. It was given to me like this and apparently there is some problem with the power supply. I have done a little bit of googling and it is supposed to have a 9v connector attached to the board. I have one, as per the pic, but I'm not entirely sure where I should be soldering it on the PCB. There are a few different versions of the board and I can't find a clear pic of this one.
So I guess I'm just after a bit of advice and direction. Is the above a reasonable place to start? Should I just buy another PCB? Who's a good local supplier?
I think I can see how the pot used for the wah attachment mechanically connects to the pedal, so I'll start fiddling with that and see how we go...
I also have a korg multi effects pedal that the wah doesn't work on...if this goes well I might investigate that as well.