Thanks again Waz
Thanks again Waz
Update on the build, nearly finished with the DT, it is an exercise in patience.
DT in cooler weather does take a fair while to go off.
# 1 - EX-5 https://goo.gl/fQJMqh
# 2 - EX-1 https://goo.gl/KSY9W9
# 3 - Non PBG Tele https://goo.gl/W14G5g
# 4 - Non PBG J Bass https://goo.gl/FbBaFy
# 5 - TL-1AR GOTM Aug 2017 https://goo.gl/sUh14s
# 6 - MMB-4 Runner-up GOTM Oct 2018https://goo.gl/gvrPkp
# 7 - ES-1 Runner-up GOTM Aug 2018https://goo.gl/T9BEY8
mmm that's got legs..
FrankenLab
Hand crafting guitars, because Death Rays are expensive.
Finally lost patience with DT top coats, taking way too long to dry properly here in Brisbane. I have now done about 4 coats of wipe on poly in the gloss and very happy with the feel and shine. Need to do a wet and dry cut next and a few more coats to call done. I think I will do the engineered fretboard too, as not overly happy with it.
Looking good.
# 1 - EX-5 https://goo.gl/fQJMqh
# 2 - EX-1 https://goo.gl/KSY9W9
# 3 - Non PBG Tele https://goo.gl/W14G5g
# 4 - Non PBG J Bass https://goo.gl/FbBaFy
# 5 - TL-1AR GOTM Aug 2017 https://goo.gl/sUh14s
# 6 - MMB-4 Runner-up GOTM Oct 2018https://goo.gl/gvrPkp
# 7 - ES-1 Runner-up GOTM Aug 2018https://goo.gl/T9BEY8
Well, life has got in the way of this build, but i am finally in the last stages of wiring, at the end i realised i had neglected to run a wire from the bridge post to earth on the tone pot. Anyone got a good tip on how to remove the TOM posts without damaging the finish? I thought i remembered seeing a post on this but i cant find it.
All sorted now, with a bit of bush engineering and some brute force with a jimmy bar the sleeve was extracted without damage.
Posting Permissions
Reply With Quote