Hi guys,
Hope you're OK !
For me, it's a bad time.. I finally survived inserting electronics inside the semi-hollow body, after a very long fight, and I just finish the last step : to glue the neck.
But.. now I'm in big trouble..
My biggest fear comes true : the fingerboard is too high, and I can't tune the strings
Maybe I didn't search enough but I couldn't find anything about this, especially for the ESB4.
So : here's my problem :
I think I'll have to unglue the neck, sand it a lot to lower it, and glue it again.
Any tips to unglue without damages ?
I think I must find a very long and thin knife, and maybe use some water's steam ?
Thank's !