+1 for leaving it as is. Looks great
Unless you make any scratchplate yourself, or get a custom one made, note that the standard Explorer ones will have a hole for the pickup selector switch at the pointy end of the scratchplate. It will look a bit odd (unless you cover the hole with a sticker or some ornamentation).
The PBG kits have the selector switch located between a master volume and master tone knob. When I get round to putting my EX kit together, I'll be routing out a cavity and cable channel and filling and re-drilling the normal selector switch hole so I can have the selector switch and the two volume + one tone control as per a Gibbo EX.
Nicely done. When you're all done I'm sure it will look great.
Completed Projects:
non PBG LP Custom - Hetfield 'Uncle Milty' Iron Cross replica
non PBG Brownstein Stratocaster
Current WIP:
non PBG Stratocaster - Canadian Red Ensign
PBG FV-1G Custom
very nice body . oh and the guitar looks great too. nice work
RedPine Lapsteel - March 2017
http://www.buildyourownguitar.com.au...hlight=redpine
JB4-A - March 2018
http://www.buildyourownguitar.com.au...ead.php?t=8006
Wonderful work, you were right not to pick guard this, it would have been a shame to over up that wood.
Sent from my iPhone using Tapatalk
FrankenLab
Hand crafting guitars, because Death Rays are expensive.
Looks great. I hope you've managed to get it intonated correctly after your hard work on the end of the fingerboard?
Looks awesome djk7! Although it's not helping my growing covetousness for an EX.
Completed Projects:
non PBG LP Custom - Hetfield 'Uncle Milty' Iron Cross replica
non PBG Brownstein Stratocaster
Current WIP:
non PBG Stratocaster - Canadian Red Ensign
PBG FV-1G Custom