I had two of those Entwistle HDNs in my Ibanez S420 guitar, they are very high output pickups with a fair bit of top end, and yes you can set them up with a Push-Pull volume pot to do coil tapping quite easily.
I had two of those Entwistle HDNs in my Ibanez S420 guitar, they are very high output pickups with a fair bit of top end, and yes you can set them up with a Push-Pull volume pot to do coil tapping quite easily.
Build 1 - Shoegazer MK1 JMA-1
Build 2 - The Relliecaster TL-1
Build 3 - The Black Cherry SG AG-1
Build 4 - The Sonicaster TL-1ish
Build 5 - The Steampunker Bass YB-4
Build 6 - The Howling Gowing ST-1
"What I lack in talent I make up for with enthusiasm"
Build 1 - Shoegazer MK1 JMA-1
Build 2 - The Relliecaster TL-1
Build 3 - The Black Cherry SG AG-1
Build 4 - The Sonicaster TL-1ish
Build 5 - The Steampunker Bass YB-4
Build 6 - The Howling Gowing ST-1
"What I lack in talent I make up for with enthusiasm"
Just had a big parcel of goodies arrive. Can't share all of it yet, but this is super exciting!
I now have everything I need to put this back together except the time Maybe this evening. I've been up working since 4:30am.. its time for a nanna nap.
Build 1 - Shoegazer MK1 JMA-1
Build 2 - The Relliecaster TL-1
Build 3 - The Black Cherry SG AG-1
Build 4 - The Sonicaster TL-1ish
Build 5 - The Steampunker Bass YB-4
Build 6 - The Howling Gowing ST-1
"What I lack in talent I make up for with enthusiasm"
Ohh baby. Just realised I still need a jack and a tone cap, but still getting close.
Any recommendations for caps? I've been reading up on them a bit, but its such a dark art until you start physically playing with the.
Build 1 - Shoegazer MK1 JMA-1
Build 2 - The Relliecaster TL-1
Build 3 - The Black Cherry SG AG-1
Build 4 - The Sonicaster TL-1ish
Build 5 - The Steampunker Bass YB-4
Build 6 - The Howling Gowing ST-1
"What I lack in talent I make up for with enthusiasm"
Always difficult to know what to go with for an HSS arrangement for pot values and cap. Side with the humbucker and have the singles slightly brighter than normal, or go with the singles and have the humbucker darker? Cap selection doesn't have any measurable effect with the tone pot fully up, but does affect the tone a lot with the pot rolled right back. Pot resistance plays a bigger part in the overall brightness of the guitar when everything's set on 10.
OK cool, thanks for that Simon. I might just suck it and see with the original cap, if it aint broke etc.
Build 1 - Shoegazer MK1 JMA-1
Build 2 - The Relliecaster TL-1
Build 3 - The Black Cherry SG AG-1
Build 4 - The Sonicaster TL-1ish
Build 5 - The Steampunker Bass YB-4
Build 6 - The Howling Gowing ST-1
"What I lack in talent I make up for with enthusiasm"
You could just try the typical tone cap value as found in LP Guitars, and try using a 500k pot for the volume control, it'll mean that the single coils will be a bit brighter than usual but that can be off-set by adjusting the tone controls to suit.
I'd be having a look to see what tone cap the typical superstrat uses and use that as a starting point when looking for the tone " you " want
Build 1 - Shoegazer MK1 JMA-1
Build 2 - The Relliecaster TL-1
Build 3 - The Black Cherry SG AG-1
Build 4 - The Sonicaster TL-1ish
Build 5 - The Steampunker Bass YB-4
Build 6 - The Howling Gowing ST-1
"What I lack in talent I make up for with enthusiasm"