# 1 - EX-5 https://goo.gl/fQJMqh
# 2 - EX-1 https://goo.gl/KSY9W9
# 3 - Non PBG Tele https://goo.gl/W14G5g
# 4 - Non PBG J Bass https://goo.gl/FbBaFy
# 5 - TL-1AR GOTM Aug 2017 https://goo.gl/sUh14s
# 6 - MMB-4 Runner-up GOTM Oct 2018https://goo.gl/gvrPkp
# 7 - ES-1 Runner-up GOTM Aug 2018https://goo.gl/T9BEY8
After a near miss for me one time I’ve taken to always putting a chunk of wood into the cavity before drilling/clearing a hole, just in case. It’s always going to happen at some point... doesn’t lessen the pain though.
Perhaps make a magnetic mount cover plate and turn the oops into the notch to pop it? Or, if you can bear to do it, make a new cover slightly enlarged on just that side and carefully rout the extra couple of mm’s to remove the gouge.
Scott.
Or you could leave it as is and wear it as a badge of dis-honour? (and a lasting reminder for 'next time').
cheers, Mark.
So other than making a rear cover I am calling this done.
Struggled with how to do a nice logo as is for my Aunt, and missus suggested a name pendant, so ordered one of ebay and paid a massive 20c for a couple of fine screws from an Optometrist and really happy how it turned out.
Tony
So next up on the bench is the attached.
What started as a single kit build to keep busy while going through some personal stuff has turned into a swagload of kit builds ( only the "Ziltoid" to finish once i can bring myself back to working on the neck again ) and now full scratch builds.
Totally hooked now.
Tony