I reckon I’ll try that beforehand burst. Thanks!!
Sent from my iPhone using Tapatalk
I reckon I’ll try that beforehand burst. Thanks!!
Sent from my iPhone using Tapatalk
Thanks @nitroburner1000 I was able to sand out most of the glue marks and restrain to make them barely noticeable. Thanks for your help.
Top and binding masked and ready for spraying. I have no idea what this will turn out like but I am going for a bit of a strange colour combo. Maybe someone can input here but I am spray a few coats of sanding sealer on but as it is ash it is soaking it all up. I will be spraying nitro on top but would still like to see a bit of the grain pattern BUT would also like the finish to be flat. Would I be able to put sanding sealer on top of the colour once it’s cured and then lacquer to get it flat...I have no idea what I’m doing
Sent from my iPad using Tapatalk
Interested to see what this combo will look like together
Sent from my iPhone using Tapatalk
Had a look at the pitbull tele wiring diagram but the switch connectors look different than the ones on the switch im using. Is there another diagram anywhere? It is still a 3 way switch
Sent from my iPhone using Tapatalk
What brand/model switch is it? I don’t recognise it from that angle so I need a bit more info before attempting to offer (bad) advice.
Scott.
Says patent pending on the side.
Sent from my iPhone using Tapatalk
I think that a gentle blue gel would look great.
Looks like jeans on a boutique coffee drinking hipster...
r
Any tips of getting lacquer runs out? Sanded down until it was flat but it seems to have eaten into the paint too. Might mask the front sides of the headstock and completely sand the front off and re spray...
Sent from my iPhone using Tapatalk