Just had a look at the Belcat website - the preamp section is huge! By any chance can you remember which one you got Pabs?
Just had a look at the Belcat website - the preamp section is huge! By any chance can you remember which one you got Pabs?
Completed Builds: #1 TL-1 "Telemaster" (GOTM Oct 2016); #2 The "Maplecaster" scratch build; #3 JB-4 "Bass IV" (co-winner GOTM Jan 2017); #4 ST-1M "Surfcaster" (GOTM Apr 2017), #5 JZA-1 "EC Deluxe"
In Progress:
Build #6 N1R "Semi-scratch" build
Build #7 JZA-1 Baritone
The Cavan Project
The Magnificent Compaņeros
http://www.ebay.com.au/itm/400368322849
This is the one. I snipped off the blend pot.
'As long as there's, you know, sex and drugs, I can do without the rock and roll.'
good score Pabs that's cheap as chips, just got to allow probably 4-6 weeks to ship from China
I'll bookmark the page in case I end up building another bass haha
Current Builds and status
scratch end grain pine tele - first clear coat on !
JBA-4 - assembled - final tweaks
Telemonster double scale tele - finish tobacco burst on body and sand neck
Completed builds
scratch oak.rose gum Jazzmaster - assembled needs setup
MK-2 Mosrite - assembled - play in
Ash tele with Baritone neck - neck pup wiring tweaks and play in
Thanks Pabs - that looks great!
Completed Builds: #1 TL-1 "Telemaster" (GOTM Oct 2016); #2 The "Maplecaster" scratch build; #3 JB-4 "Bass IV" (co-winner GOTM Jan 2017); #4 ST-1M "Surfcaster" (GOTM Apr 2017), #5 JZA-1 "EC Deluxe"
In Progress:
Build #6 N1R "Semi-scratch" build
Build #7 JZA-1 Baritone
The Cavan Project
The Magnificent Compaņeros
better order it soon Chuck, says delivery could be up to late February !
Current Builds and status
scratch end grain pine tele - first clear coat on !
JBA-4 - assembled - final tweaks
Telemonster double scale tele - finish tobacco burst on body and sand neck
Completed builds
scratch oak.rose gum Jazzmaster - assembled needs setup
MK-2 Mosrite - assembled - play in
Ash tele with Baritone neck - neck pup wiring tweaks and play in
I know! I know!
It's the same arrangement as on an OLP MM copy I had. Each coil of the pickup is wired out to its own volume control and there's a common tone control. So it's rather like a standard JB arrangement, except the two coils are sitting next to each other rather than spaced apart.
The PBG wiring diagram shows it: http://www.pitbullguitars.com/wp-con...MMB-4_2014.pdf
On the OLP, the effect of both coils on fully was a very full deep rich sound, a lot thicker than a PB sound and not really like two single coils in parallel. But that's obviously how they're wired on the PBG kit. By mixing the two volume levels you could get quite a wide range of tones - though unless the volumes were matched, you did get some buzz creeping in as you lost the noise-cancelling effect.
Yep, it's probably a bit clearer with the SD MM 2V 1T diagram (for those interested).
Scott.
Thanks Simon and Weirdy, those two diagrams finally have it making sense!
Completed Builds: #1 TL-1 "Telemaster" (GOTM Oct 2016); #2 The "Maplecaster" scratch build; #3 JB-4 "Bass IV" (co-winner GOTM Jan 2017); #4 ST-1M "Surfcaster" (GOTM Apr 2017), #5 JZA-1 "EC Deluxe"
In Progress:
Build #6 N1R "Semi-scratch" build
Build #7 JZA-1 Baritone
The Cavan Project
The Magnificent Compaņeros