Hi all!!!
Thought I would start a build diary since I was too slack to take photos the last time.
So here goes, Santa dropped by and left an ES-1G kit under the tree for me, THANKS SANTA!!!! Anyway this looks like it could be a whole different kind of beast to the ST-1 kit so I could use all the help I can get
I unboxed the kit and the neck fits nice and snug, the humbucker routes are a little tight in the corners.
The back of the guitar has some pretty sexy grain.
Somethings I did notice though were a bit of a rough joint along the bottom of the neck pocket.
A few rough bits along the binding
The thing I noticed that worries me most is the high side of the fret board is rounded at the body end of the neck leaving the ends of the frets sticking up, any tips?
Any words of wisdom are much appreciated.