Hey all.
I've decided to replace the fret dots with abalone on an upcoming project. Anybody know the fret dot size on an ES-1G?
Hey all.
I've decided to replace the fret dots with abalone on an upcoming project. Anybody know the fret dot size on an ES-1G?
Pretty sure they're a standard 6mm diameter.
'As long as there's, you know, sex and drugs, I can do without the rock and roll.'
Hi Jeff, as Pabs says think they are 6mm but if you have a 1/4" (6.35mm) brad point drill just order 6.35mm (1/4") abalone markers.
Current Builds and status
scratch end grain pine tele - first clear coat on !
JBA-4 - assembled - final tweaks
Telemonster double scale tele - finish tobacco burst on body and sand neck
Completed builds
scratch oak.rose gum Jazzmaster - assembled needs setup
MK-2 Mosrite - assembled - play in
Ash tele with Baritone neck - neck pup wiring tweaks and play in
Yep, 6mm diameter (double-checked it this afternoon).
Scott.
I replaced mine with 6mm abalone dots......always order at least one more than you need ...just in case you stuff one of them...
Build #1 - ST-1 - Completed
Build #2 - LP-1SS - Completed
Build #3 - TLA-1R - Completed
Build #4 - SGD-612 - Completed
Build #5 - ES-1G - Completed
Build #6 - STA-1HT | Completed
Build #7 - ST1JR - Completed
Current Build #8 - JBA-4
Build #9 - Semi-scratch build Tele x 2 - Completed
Current Build #10 - PRS-1H
Current Build #11 - AGJR-1 - Completed
Current Build #12 - ATL-1SB
Current Build #13 - GST-1
Current Build #14 - FBM-1